Contact Points - SOLVED

[patchz]

The default EH101 is listing to starboard and it appears that the right hydraulic is compressed more than the left. But I can't figure out what to change to fix it. Can anyone point (no pun intended) me in the right direction?




[contact_points]
;gear
point.0=1,

[Bob70]

Looks to me like a leaky seal. Add a little fluid till you can get it replaced.  (no pun intended) 

Bob

[Hagar]

Those contact points look fine to me.

[patchz]

No wind, joystick unplugged, same result after rotor stops.

[Felix/FFDS]

Check that you haven't inadvertently change the weight/balance distribution in the payload/fuel dialog..

[patchz]

Check that you haven't inadvertently change the weight/balance distribution in the payload/fuel dialog..

Already did, everything is balanced.

[garryrussell]

Odd thing...

Your tyres are further into the ground than Hagars and the nose wheel tyres are well into the ground yet the suspension looks unloaded. :-?

Is it just at that site or is it like that wherever you land?? :-/

Is your rotor disk level??

Garry

[Felix/FFDS]

Pray tell, how was it solved?

[patchz]

I was attempting to add 'floats' to it. I had first made some changes in that section without results and 'assumed' it was not related to that. I finally removed the floats section and that fixed it. I put the float section back and started from the beginning and finally found the correct entry to modify. Just have to a little fine tuning now.

[Felix/FFDS]

Thanks - it's always good to share that stuff.  You have no idea how many times reading a snippet like that has helped me avoid a problem ....