by dave3cu » Sun Jun 03, 2007 9:50 am
There are some default airports where things don't line up or connect properly. This can most often be fixed by editing the airport in Afcad.
You don't say what airports, all or a few....default airports or addons. Is this something that started recently, or has it always been a problem?
A screen shot or 2, and/or identifying the airport(s) and problem taxiways might help narrow down the cause.
Do things just not match up or are there areas missing? Have you installed/removed any scenery that included airport environment .bmp's (runway*.bmp or taxi*.bmp)?
Dave
Last edited by
dave3cu on Sun Jun 03, 2007 9:56 am, edited 1 time in total.
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.