by garymbuska » Mon Mar 29, 2004 12:38 pm
Mike
Not quite sure what you mean by load manager, but if you are tlaking about changing weight and balance for each plane. That can be done by two ways.
1). click on the aircraft tab then click on fuel and weight tab then the payload tab. Here you can enter or change a weight
2). This way can get a little complicated as it envoles changing the aircraft cfg file. each plane has a weight and balance section and it is here where you can add weight to specific places in the air craft.
If you use the 2nd option I would suggest you look at some of the default aircraft and you will see lines in the weight and balance which look something like (STATION1=*****) I am not sure of the actual wording I am at work but I konw it is something like that I am not sure what each parameter is doing here and the order they are in. Which is why I never mess with this section.
I usually change the payload and fuel in the fist method to change weights.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
