Removing Scale

[Oz]

How do i remove the 'nodes' on some parts of a model? I keep getting an error during conversion that tells me that i gotta remove the node...how can i do this?

[Felix/FFDS]

gmax?  What does your error log tell you?

How do i remove the 'nodes' on some parts of a model? I keep getting an error during conversion that tells me that i gotta remove the node...how can i do this?

[Oz]

Ok my bad its a scale thats the problem. (Gmax) Heres what i get

Node (part name) has a scale applied. Must remove before exporting.

I had to scale the part in the begining and i cannot delete it. Is there anyway to correct this error?

[Felix/FFDS]

If memory serves me right, there should be an Xform - reset scale modifier.  Select the part, and apply the modifier.

(it goes without saying on any advice I give - make a backup copy of the project first...

Ok my bad its a scale thats the problem. (Gmax) Heres what i get

Node (part name) has a scale applied. Must remove before exporting.

I had to scale the part in the begining and i cannot delete it. Is there anyway to correct this error?

[Oz]

thanks ill try that out

[Oz]

well i think i correctly followed an Xform direction in the help reference but i still receive the same error. I think maybe i might be doing it wrong, can you tell me the proper way of removing the scale from a part that already has it applied?

[Felix/FFDS]

Select all parts, then ....

"Click on Hierarchy/Transform/Reset Scale to eliminate any potential scale errors in the exterior"

This is from one of the "Tips" by Dennis Simanaitis posted in the Freeflight Design Shop's TIPS Section (avoiding the dreaded Scale error...)

well i think i correctly followed an Xform direction in the help reference but i still receive the same error. I think maybe i might be doing it wrong, can you tell me the proper way of removing the scale from a part that already has it applied?

[Oz]

thanks so much Felix  :D

[Moach]

im having that same problem

i just followed that procedure but im still getting the messages

well it doesn't stop the exporting, so i don't worry too much about it

[Oz]

i press trasform and scale and the error message goes away.