I think this is not quite the case. Concorde intake ramps are only moved past Mach 1,7. A plenty of fighters with turbojets and low bypass turbofans go supersonic in the region of Mach 1 to 1,5 without complicated variable intakes.
EDIT..Just found this, so ignore my ramblings below, this website explains it all very well:
http://selair.selkirk.bc.ca/aerodynamic ... Page7.htmlRule of thumb (and not some NASA out there experimental stuff) is that air intake speed MUST be below supersonic speed. For subsonic aircraft, the air intake to a jet engine presents no special difficulties, and consists essentially of an opening which is designed to minimise drag. However, the air reaching the compressor of a normal jet engine must be travelling below the speed of sound, even for supersonic aircraft, to sustain the flow mechanics of the compressor and turbine blades. At supersonic flight speeds, shockwaves form in the intake system and reduce the air speed at inlet to the compressor. Some supersonic intakes use devices, such as a cone or ramp to augment this, to slow the air down by varying the intake shape. If you where to cut the intake vertically in two, you would see, if memory recalls a divergent duct shape, allowing velocity to decrease, pressure increase and temperature to also increase.
As for Concord, I did read once that the air speed in front of the engine intake was only about 300mph.
Matt
"A bit of a pickle" - British translation: A catastrophically bad situation with potentially fatal consequences.
PETA

People Eating Tasty Animals.
B1 (Cat C) licenced engineer, Boeing 737NG 600/700/800/900 Airbus A318/19/20/21 and Dash8 Q-400
1. Captain, if the problem is not entered into the technical logbook.........then the aircraft does not have a problem.
2. And, if you have time to write the fault on a napkin and attach to it to the yoke.........you have time to write it in the tech log....see point 1.