f16 panel

[flying_weasel]

Hi Guys
Can any one help, I am using fs2002 and have recently downloaded the great  Kirk O  f-16 and also the 2D  panel ,I have noticed that I am getting 5 small black boxes i.e. blank gauges one on top of each other directly over the lower center Altitude gauge  they are the same size as the A.I. is there any way I can get rid
Flying Weasel

[Sam 400]

Was it the Full F16 panel found on page 12 of the panel page section http://www.simviation.com/fs2002panels12.htm as this is the one I downloaded and I have no problem. Sam

[flying_weasel]

Hi
without going back and checking I think it was it was the one the one recommended to use,
Flying weasel

[Sam 400]

I don't know wether it was as I only downloaded the aircraft recently and went straight for that file without looking at the reccomended one as I'd been told it was good. It might be the same one. Have a check please. Sam

[flying_weasel]

Hi Sam
Thanks for that I will go and check
Timm

[flying_weasel]

Hi Sam
Yes I got the one from page 12, I had a look at the panel config and matched it up with another F16 I found that some of the window section were missing and some not numbered so redone and hey presto all working ok. on another matter how did you get on with the new after burner effects ? I seem to get long stricky lines coming I have downloaded the Typhoon but still no change