Make it stop!!!!

[MattNW]

I have the Fleet Canuck that I downloaded here at Simviation. Whenever I fly it I get a continous morse code identifier that doesn't stop. I've tried changing frequencies and the keyboard shortcuts to turn off all identifiers but nothing stops it. It's a nice plane but that noise for an hour without stop drives me crazy. The only way I can stop it is to turn off power to all avionics equipment. That stops it but it also leaves me without any avionics.

[Smoke2much]

If you go into the settings/sounds you can adjust all of your volumes.  Either turn the engine noise up or the navigational aids noise sounds down.

Will

[BE58D]

Or make sure that none of IDENTs are turned on for the NAV1, NAV2, ADF or the MARKER BEACONS.  This is found on the audio panel, usually above the radio stack.

[MattNW]

I've turned the idents off, or at least tried to. It seems to be limited to only the one aircraft, Fleet Canuck 80 Floats. When I switch to another aircraft the sound stops but when I switch back it's there again. It also seems to be one of two different identifiers either

"- - - . - . - . ." or ". - . ."

wich doesn't change no matter where I am or how far I fly I never seem to get out of range. It has to be a quirk with the configuration file or something. I guess on this aircraft I'll have to do without auditory idents and double check my navigation frequency settings.

I like the plane but for this one little quirk.

[phil509]

Its a classic GREMLIN

[MattNW]

Its a classic GREMLIN

Well, I just kicked the sucker out to walk at 5000 AGL. Don't know what I really did but I compared the Canuck .cfg file to the Lake Renegade file and the section on radios had one difference. I changed:

"Audio.1=0"

to:

"Audio.1=1"

and I don't have the noise any more.

Now does anyone know what the heck I did?  ???

[Imzzaudae]

- - - = O .-. =R -.. =D   ORD

Chichago 113.9
Take another look at the ident buttins eather nav one
or 2 ident is on.

Best of luck

[FSTipster]

[quote]

Well, I just kicked the sucker out to walk at 5000 AGL. Don't know what I really did but I compared the Canuck .cfg file to the Lake Renegade file and the section on radios had one difference. I changed:

"Audio.1=0"

to:

"Audio.1=1"

and I don't have the noise any more.

Now does anyone know what the heck I did?

[MattNW]

[quote]


Enabled the audio panel in the aircraft, despite the fact that