Knife-Edge?

If it doesn't fit .. It fits here .. - -

Knife-Edge?

Postby Foxtrot Sport » Tue Jun 27, 2006 10:08 pm

During the past few airshows I've been to, I always see at least a few performers claim that their aircraft can fly even without the wings generating lift.  They roll the plane 90 degrees, and say that the only thing holding the plane up is the vertical stabilizer (that is now horizontal mind you).

How in the world do they figure that this 'knife-edge' flight is including the wings not generating lift?  The wings are still going through air, thus creating lift, right?  Of course, one couldn't do this without the correct rudder compensation, but still, the wings still work!

Any clarification?
Image
Formerly HighFlyer24
User avatar
Foxtrot Sport
Major
Major
 
Posts: 1027
Joined: Wed Jun 30, 2004 12:33 pm
Location: Sacramento, California

Re: Knife-Edge?

Postby Mobius » Wed Jun 28, 2006 1:26 am

They do, but the component of lift they create is horizontal, therefore perpendicular to the ground, and the force of gravity, so the lift generated by the wings isn't doing anything to keep the aircraft in the air. ;)
Last edited by Mobius on Wed Jun 28, 2006 1:26 am, edited 1 time in total.
Image
User avatar
Mobius
Major
Major
 
Posts: 3653
Joined: Thu Nov 04, 2004 10:44 pm
Location: Wisconsin

Re: Knife-Edge?

Postby Brett_Henderson » Wed Jun 28, 2006 6:25 am

If the plane isn't turning (i.e.  if it can hold that knife-edge straight down a runway), it's not flying. It's more like a rock "flying" on momentum and hanging on the prop.

It would be losing airspeed quickly... or have a disproportionately low airspeed for that power setting... maintaining altitude by thrust and control surface deflection. That aint flying.. thats being a missile..

As the old saying goes..  A barn door will "fly" with enough, applied thrust.
Brett_Henderson
Major
Major
 
Posts: 3403
Joined: Fri Oct 08, 2004 7:09 am

Re: Knife-Edge?

Postby beaky » Wed Jun 28, 2006 6:38 am

They are only controlling their angle relative to the horizon with rudder, but the  fuselage (which is usually just a little more like an airfoil than a barn door) itself provides some lift.... I've heard more than one airshow announcer describe it that way. The vertical stab probably doesn't have enough surface area to provide enough lift. But it no doubt helps!

Knowing that, and having seen some very low-alt and low-airspeed knife-edge passes, I disagree that it's a matter of ballistics (the "missile" analogy). Thrust is a must, of course, because for level flight in any attitude lift, thrust, weight, and drag must all reach a certain equilibrium, and losing the lift component of the wings against the weight of the plane requires more thrust to re-balance the equation.
But it's true, the lift component of the wings, regardless of the attitude of the plane, is always within a few degrees of perpendicular to the top or bottom surface of the wings, and as long as they're moving through the air forwards, they will produce lift.
 in knife-edge flight, they will produce some lift (now horizontal, relative to the ground)), requiring elevator input to keep the plane on a straight line.
I'd guess that even with the nearly-symmetrical airfoils found on most aerobatic planes, the wing would produce a little more lift towards the top surface, even though it's vertical.
Haven't done it in RL (only loops and rolls), but when I do this in the sim, I find myself adding a little forward stick to stay on the "show centerline".
Last edited by beaky on Wed Jun 28, 2006 6:45 am, edited 1 time in total.
Image
User avatar
beaky
Global Moderator
Global Moderator
 
Posts: 12877
Joined: Thu Dec 16, 2004 8:00 am
Location: Shenandoah, PA USA

Re: Knife-Edge?

Postby Brett_Henderson » Wed Jun 28, 2006 7:15 am

I'll have to "re-disagree"
Last edited by Brett_Henderson on Wed Jun 28, 2006 7:17 am, edited 1 time in total.
Brett_Henderson
Major
Major
 
Posts: 3403
Joined: Fri Oct 08, 2004 7:09 am

Re: Knife-Edge?

Postby Hagar » Wed Jun 28, 2006 9:24 am

High-performance aerobatic types like the Extra 300 & Sukhoi SU-26 have fully symmetrical aerofoil sections set at zero incidence to the thrust line so you can discount any "lift" from the wings in knife-edge. The amount of lift produced by the fuselage is debatable. These aircraft have an extemely high power-to-weight ratio. In a prolonged knife-edge pass the main lift is coming from the sheer power of the engine held at a high "angle of attack" by top rudder.
Image

Founder & Sole Member - Grumpy's Over the Hill Club for Veteran Virtual Aviators
Member of the Fox Four Group
My Google Photos albums
My Flickr albums
User avatar
Hagar
Colonel
Colonel
 
Posts: 30864
Joined: Wed Jun 19, 2002 7:15 am
Location: Costa Geriatrica

Re: Knife-Edge?

Postby Foxtrot Sport » Wed Jun 28, 2006 9:32 pm

Well yes, taking into account the amount of elevator compensation, the wings are still holding the plane up aren't they?

Say when a plane is traveling straight and level, and the stick is pushed forward like it would have to be in knife-edge flight, the wings are still producing lift and flying the plane, right?
Image
Formerly HighFlyer24
User avatar
Foxtrot Sport
Major
Major
 
Posts: 1027
Joined: Wed Jun 30, 2004 12:33 pm
Location: Sacramento, California

Re: Knife-Edge?

Postby H » Thu Jun 29, 2006 12:10 am

Well yes, taking into account the amount of elevator compensation, the wings are still holding the plane up aren't they?
Say when a plane is traveling straight and level, and the stick is pushed forward like it would have to be in knife-edge flight, the wings are still producing lift and flying the plane, right?
Everyone here has mentioned something that has an effect, HighFlyer. However, in knife edge flight, the wings aren't providing the lift that is keeping the plane up: the major contributed lift is actually from the propeller since that is what's providing the thrust. A  football (American type would be the best example) would stay in flight much longer with stabilizers attached (as does a feathered arrow); if it had its own power plant... :o
Understand that the plane is already in flight and only needs enough lift to sustain flight, not take off.


8)
H
Lieutenant Colonel
Lieutenant Colonel
 
Posts: 5525
Joined: Fri May 27, 2005 1:27 am
Location: NH, USA

Re: Knife-Edge?

Postby Hagar » Thu Jun 29, 2006 1:57 am

Say when a plane is traveling straight and level, and the stick is pushed forward like it would have to be in knife-edge flight, the wings are still producing lift and flying the plane, right?

In a word - No. You seem to have the wrong idea about this. In knife-edge the wings are vertical & producing no conventional lift at all. The elevator now acts as a rudder with the rudder used as an elevator to keep the nose up & maintain straight and level flight. This is known as "top rudder". Without power the aircraft would fall out of the sky.

Image
Last edited by Hagar on Thu Jun 29, 2006 3:08 am, edited 1 time in total.
Image

Founder & Sole Member - Grumpy's Over the Hill Club for Veteran Virtual Aviators
Member of the Fox Four Group
My Google Photos albums
My Flickr albums
User avatar
Hagar
Colonel
Colonel
 
Posts: 30864
Joined: Wed Jun 19, 2002 7:15 am
Location: Costa Geriatrica

Re: Knife-Edge?

Postby Chris_F » Thu Jun 29, 2006 6:26 am

Well yes, taking into account the amount of elevator compensation, the wings are still holding the plane up aren't they?


To elaborate on what Hagar said...

Airfoils (either the wings, or the rudder, or the fuselage in some cases) can only produce lift in a direction perpendicular to the wing.  "Lift" by definition is vertical relative to the earth's surface to counteract gravity.  So "lift" has to occur in an upward direction.

Now, imagine an aircraft with a big arrow pointing out of each wing.  And imagine the sun low on the horizon.  The aircraft flies in front of a giant movie screen and the sun casts a shadow of the aircraft and the two arrows on that screen.  The size of the shadow of those arrows is like the lift produced by the wings.

The plane repeats this, only at a 45 degree bank.  The shadow the arrows cast is now shorter, right?  The arrows themselves (the force the wings produce) are the same size, but the shadow is shorter because it's at an angle.  That's because part of the force the wings produce is lifting the plane, and part is turning the plane.

Now the plane flies a knife edge.  The shadows are gone.  But the force remains.  So the wings still produce force, but no lift.
Chris_F
Major
Major
 
Posts: 1364
Joined: Thu Aug 19, 2004 5:59 pm

Re: Knife-Edge?

Postby Ivan » Thu Jun 29, 2006 1:42 pm

with 450hp up front the only limits are newton and the pilot capabilities
Russian planes: IL-76 (all standard length ones),  Tu-154 and Il-62, Tu-134 and [url=http://an24.uw.hu/]An-24RV[/ur
Ivan
Lieutenant Colonel
Lieutenant Colonel
 
Posts: 5805
Joined: Sun Apr 13, 2003 8:18 am
Location: The netherlands

~

Postby Scorpiоn » Sat Jul 01, 2006 8:09 pm

Unless you're flying a C-5A.
The Devil's Advocate.
Image
User avatar
Scorpiоn
Major
Major
 
Posts: 3734
Joined: Thu Jan 31, 2002 7:32 pm
Location: The Alamo

Re: Knife-Edge?

Postby SkyNoz » Sun Jul 02, 2006 1:38 am

hmmm, the wings take the place of the vertical stab and the Rudder becomes the elevator to keep the aircraft airborne.....
Last edited by SkyNoz on Sun Jul 02, 2006 1:41 am, edited 1 time in total.
Project Kfir!
Image
My Gmax page
Aircraft modeler/Aircarft painter

Aye the key!
[GeneralEngineData]
//0=Piston, 1=Jet, 2=N
SkyNoz
Major
Major
 
Posts: 1703
Joined: Sat Aug 06, 2005 11:02 am

Re: Knife-Edge?

Postby Alphajet_Enthusiast » Mon Jul 03, 2006 12:17 pm

Saw a knife edge pass just yesterday... Either it was the Patrouille de Suisse (you can see the same display at RIAT in a few weeks) or a Swiss or Belgian solo display can't remember.... in any case it was awesome!  :)
Image
Macbook Pro | Nvidia Geforce 8600M GT | 2GB Ram | 2.6GHz Intel Core 2 Duo | Mac OSX 10.5 Leopard
User avatar
Alphajet_Enthusiast
Major
Major
 
Posts: 2858
Joined: Mon Jan 03, 2005 12:49 pm


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 461 guests