by garymbuska » Thu Nov 29, 2007 12:48 pm
Last night I went for a flight with a danish SAR S-61 helicopter from ETME Eggebeck Air Base in North Germany heading for EKSB Soenderborg Airport in Denmark, and just 10 miles before I reached EKSB the FS 2004 stopped and reported af failure "fe.dll" what can I do ??, :-/
then I tried a couple of times more and the same failure came again. :-/
any help or advise I will like very much.
a Danish flightsimmer
Otto Knudsen
Have you tried to use a different helicopter? The file you refer to is a DLL file and probably should be in your module folder if this file is found some place else within FS you might want to move it to the module folder and retry the flight. Most but not all DLL files belong in the module folder and the aircraft you are using may have come with this file. If this is the case it more than likely needs to be in the module folder 8-)
Last edited by
garymbuska on Thu Nov 29, 2007 12:50 pm, edited 1 time in total.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
