Throttle control

[dcs1968]

I have run into a problem with multi-engine planes that for the life of me I can't solve. When I use my throttle control on my joystick or use keyboard comands the #1 engine is the only one to respond. It does not matter if I am flying a default aircraft or add-on.  I have tried key asignments but it will only let me set for one engine for that key comand or joystick throttle. I want all engines to be controled by one command.

Thank You in advance for any help

[garymbuska]

Usually what happens here is that the default flight was saved with the throttles unlocked and it will pre sent problems every time it loads. If you rename your default flight it will not load it and that might solve your problem. If not try the following with the throttles gauge displayed press the F4 and F1 keys this should make all throttles go from minimum to full. If this does not work try renameing your FS9 cfg file and restart the sim. And if that fails well you are up a pollouted tributary without sufficent means of transpertation.

[swordfish1227]

press "e" and then number keys 1-6, usually works for me.

also make sure you have the correct assignment

[dcs1968]

Thanks for the input. Unfortunatly I won't have an opportunity to try this untill this weekend.

[kilotango]

I must say. I dont understand this! If you are not using the cougar or CH, and dont have any program in your flightstick, then go to the calibration in window or the sim and save it.
If you are using FSUIPC then check the setup.