Leeming problem

[flyingbart]

Can anyone help ive installed the fanatastic scenery of Raf Leeming  version 1 & 2only to find it keeps shutting down. Ive checked with AFCAD to see if there are any faults but there arent .carnt understand why fs9 isnt letting it boot up. I dont have any flight plans yet for this base so i know its nothing to do with that.
can anyone help
cheers flyingbart

[logjam]

Perhaps the problem is that you have both versions loaded. Version 1 was intended for FS2002, tho it worked quite well in FS9. Version 2 is programmed differently for FS9 and doesn't have the static Hawk squadrons. I would suggest you unload version 1 and try that.

[bm]

Make sure as logjam suggests you don't have the two installed concurrently.

Apart from that the only thing I can think of is the tree library - did you install the library contained in the zip? If you did (if you didn't it should run fine) have a check in \Scenery\Generic\Scenery & \Addon Scenery\Scenery and make sure you don't have a duplicate or occurrence of Agen_XTrees_lib9.BGL, Agen_XTrees_lib9_1.BGL & Agen_XTrees_lib9_2.BGL. You can also try deleting the folder (if you havent after you've installed the library) Agen_XTrees_lib9_2 in the Leeming V2 addon scenery folder.

[brittair]

Sorry you are having a problems but this is a first on me.

Try Logjam and Bird's suggestions and let me know how you get on.

[flyingbart]

cheers guys just got in from work so am going to have a go at birdman & logjams ideas shall report back later
cheers flying bart

[flyingbart]

Hi guys ive uninstalled v1 and put v2 straight into my addon scenery and then ive gone to scenery library and added it .Ive also put the BGL  Agen XTrees lib9 2 file in scenery ,generic, scenery file .The tree textures are in my main fs9 textures folder  from v1 thought id keep these in my texture folder as v2 doesnt have any textures for trees. Right when i boot up fs9 i go to search location addon scenery to find no raf leeming. But if i put version v1 in and do the same i get raf leeming and the base appears when you start up only to find when you taxy from the HAS to the runway and roll it shuts down. Could it be because I use VFR 4 northern england it doesnt like it. I run a p4 3ghz 1024 ddr 3200 ram  radeon 9600xt so shouldnt have any probs
cheers guys
flyingbart

[flyingbart]

Found the problem guys a couple of my airports that ive recently edited using AFCAD had some faults this caused my fs9 to shut down thinking it was something to do with the new scenery of leeming which i had put on. sorry for the hassle guys and thanks for your support