by garymbuska » Fri Aug 13, 2004 7:55 am
I gather you mean ILS not irl
If you open the map view than click on the airport it will display all of the run ways & give you the nav setting and course setting of any ils runway. Just set nav1 to the freq. then set your course not your heading to the approiate setting & make sure your nav gps switch is set to nav. when you get close enough you should pick up the glide slope then follow that in. Pay attention to the bar on either side of the arrow as that tells you which side of the runway you are on.
If this confuses you I suggest you go to the learning center and read up on NAVIGATION.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
PhotoShop 7 user
