by garymbuska » Sat Feb 25, 2006 12:19 pm
What you have to do is start AFCAD then enter the airport code you want in the search box. Once it loads the airport Select the LISTS menu at the top in afcad and highlight the run way you want to check then select properties and make sure the make inactive for landing and take off is not checked.
AFCAD has a good help file that explains how to use it. AFCAD is a handy tool to have around.
TAke a look at KSFO it has twin runways and both are active
at least they are in fs2004.
Last edited by
garymbuska on Sat Feb 25, 2006 12:24 pm, edited 1 time in total.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
