Problem with airport & AFCAD

[Roberto]

Hello there!

I'm having a bit of a problem with an airport and an AFCAD file I downloaded for LJLJ.

In reality 99% of all flights take off in one direction (RW13) and land in the opposite dirrection (RW31). When I set this up in AFCAD, by closing for takeoff/landing all flights take off on RW and all land also on RW13 and not RW31.

[flyboy 28]

You need to change where the wind comes from in the weather settings.

[Roberto]

Nope, that's not the problem or solution!

I know I had it done previously (i think in FS2002) irrelevant of wind direction.

This is an AFCAD issue. I closed the certain RW for landings but it's still used!

[garymbuska]

Not sure but I think you have to do more than just use AFCAD to close a runway for landing as the orignal BGL file for that airport is still there. I rember A VOR that was in the middle of a stock FS2004 runway and in order to make it move I had to make a seperate bgl file for that airport even though I had moved it with AFCAD it still showed up.
You might have to this as well in order to put a runway out of service but I am not sure I have never tried this.
I think the airport was Vostock or smoething like that.