Grouping in AFCAD2

[romaruk]

Hi All

I have adjusted Exeter airport adding some new taxiways etc.  When i check for faults it tells me that the new taxiways etc are not joined or attatched.  I have read the manual, but it doesn't tell you how to group everything so it becomes one.  Any ideas????  Also, after doing this, will the AI aircraft use the new taxiways???

Many Thanks

Steve

[garymbuska]

You have to make sure that all of the nodes connect to each other. As for AI using the new taxi ways I doubt if they will. But I am not sure on that just make sure you save the changed airport. I put all of my AFCAD files in the addon scenery in a folder named AFCAD and a subfolder named Scenery. By doing it this way any time I add a file fs will rebuild the scenry indexes without me having to addit manually.