AI aircraft and afcad

[data790]

How do I get AI traffic on afcad? I have made an airport yet i don't know how to assigne aircraft to the airport.

Also, how do you make buildings and other wonderful creations after the airport has been built???

[garymbuska]

You do not use AFCAD to add ai trafic to a airport.
You can assign parking spaces for AI aircraft but in order for AI aircraft to fly in & out of the airport you have to make flight plans for them. You should check out simple AI is very straight forward and give you all the info you will need to add ai to any airport. You might also want to get TTOOLS to add the flight plans to FS.
Or check out www.project.com
They have a ton of AI flight plans ready to go.

[data790]

Thanks for the info. I have already got ttools, and have used it loads. what I am really after is how to make an airport except AI traffic.

Eg. If I wanted RAF Marham to except AI traffic how would i go about doing that? At the moment it will not do this.

[planespotter]

you will need to add this airport to the AI airport list.

click on the properties of your  afcad, the info should look like this.

KNUW,N48* 21.09',W122* 39.36',46
KNZY,N32* 41.79',W117* 12.63',26

Make sure you run the fault finder in afcad to make sure there are no problems with the afcad file