FLATTEX PROBLEM

[joracing3]

I AM NEW TO THIS SO THIS MAY BE A DUMB QUESTION BUT' HERE GO'S. I HAVE AFCAD 2.2 AND RWY 12 I AM TRYING TO UPDATE AN AIRPOT AZU I WENT IN AND FLATTEN AN EXCLUDED THEN I STARTED MY PROJECT WITH AFCAD WHEN I WAS FINISHED IT WOULD'NT SHOW UP SO I UNDID THE EXCLUDE AND IT WAS THERE BUT HAD TREES ON THE APRONS AND RUNWAYS I THOUGHT FLATTEX WOULD ONLY EXCLUDE DEFAULT SCENERY CAN SOMEONE PLLZ FILL ME IN ON HOW TO DO THIS THX

[Sakura]

I may know nothing about scenery design but I know that the pros are more likely to respond if you don't captialize every letter.

[avp_bluearmy]

I got a similar problem, oh and yes i am back btw... i havent been on on a while, have i? well...

I ussed to be good at this, but since i lost my copy of FS9 back in memphis i havent done it on a while.

I am trying to exclude, but where is the .cfg file? i cant remember...