Installing a working windsock

[mauricegambles]

Does anyone know how I can install a working windsock in FS2004 using either FSSC or AFCAD ?

[racartron]

What do ya mean by "workijg?" The default one changes slope and direction based on wind velocity and source -- doesn't it? It does that in FS2002 -- where I fly.

[Hagar]

What do ya mean by "workijg?" The default one changes slope and direction based on wind velocity and source -- doesn't it? It does that in FS2002 -- where I fly.

Exactly.

Maurice. I don't know the answer but think it should be possible. I suggest you might do better in the Scenery Design forum.

On your other topic, I successfully removed the default runway on Mull with AFCAD. This leaves a grass strip that doesn't look too bad. I don't know how to change the texture or how it's defined.

[mauricegambles]

Thanks both for the replies.

Yes the default windsock in FS2004 that appears at some airports does work as described, but how would I use the default windsock as a macro or otherwise add it to a location where it does not exist ?

I too removed the airport at Glenforsa to the correct location using AFCAD, but cannot as you say remove the original ground texture and profile.

I will try the scenery forum as you suggest