Painting Brett's Bonanza

[Frequent Flyer]

I finally decided to paint Brett's Bonanza, and the paintkit is works perfect apart for 2 places that don't seem to paint:

1) The area between the two tails
2) The front areas of the nose.

I'd appreciate it if someone could point out where on the paintkit I should paint to color these areas.

Thanks alot, and another thank you to Brett for creating this amazing bird.
Frequent Flyer

[skoker]

Well the nose paint is below the tyre texture, but I can't find a separate texture for that tail thing... :-/

[Frequent Flyer]

Well the nose paint is below the tyre texture, but I can't find a separate texture for that tail thing... :-/

Thanks, found it on the paintkit.

Anyone knows where I can paint the roof are? [See picture]

[Brett_Henderson]

Take a look at the original paint..  see where it  has to "stagger" ?  That's the top of the empenage..

[Frequent Flyer]

[quote]Take a look at the original paint..

[Frequent Flyer]

One last question:
Where do I paint (actually, un-paint) the following places?

That's the antenna and some parts of the 1st window on the right side.

Thanks!

[Brett_Henderson]

The door is mapped to align with the right side of the fuselage. It is a planar map, and the fuselage halfs are mapped by selected polygons from a cylindrical UVW. The door mapping "stretches" a bit, and is picking up part of the stripe along the top.. You'll have to narrow that strip a bit.

The antenna is mapped so that it maches the "roof".

Long story short.. you can't stripe the roof..  due to short-comings in my mapping skill (patience   :P )

[Frequent Flyer]

[quote]The door is mapped to align with the right side of the fuselage. It is a planar map, and the fuselage halfs are mapped by selected polygons from a cylindrical UVW. The door mapping "stretches" a bit, and is picking up part of the stripe along the top.. You'll have to narrow that strip a bit.

The antenna is mapped so that it maches the "roof".

Long story short.. you can't stripe the roof..