Create Poly ?

[hsvfan]

Hi all,
Can someone tell me how to use the create poly. I have created an aircraft panel, but I neen to round it off at the back. I dont think I have a enough polys to make any changes to round of the panel  

Cheers hsv  

[garymbuska]

The best advice I can give is TUTE TUTE TUTE use the tutorials. It is a bit lengthy tyring to describe how to make a poly to use for a panel.

[Milton]

hsv,

An easier way may be to go into edge sub-object mode, select each top edge, then Divide.  This breaks the edge into two pieces and creates the vertice you need to round off the top.

Hope this helps.