thrust vectoring

[Hellhound]

i had an idea for vectoring thrust. have the exaust for the jet engine named the flap! that way you can extend the flaps and open the tailhook for a fan in the front (to keep it steady. i think it was on one of the joint strike fighters) and viola! thrust vectoring!

[Felix/FFDS]

If you have a VTOL lift fan (JSF), you don't have a tailhook.

However, your idea to use the flaps as the key toggle is rather correct.   Since the FS engine doesn't support true VTOL operations, exagerating lift on flaps is *usually* used for this effect (as a result you don't get a true VTOL, but rather a very short take off run)

[Hellhound]

i was saying use the tailhook animation for the fan cover opening.

[Felix/FFDS]

i was saying use the tailhook animation for the fan cover opening.

True enough, but wouldn't you want everything coordinated?  You wouldn't open the fan cover unless you're going into hover flight, etc (operating flaps)

Of course, in FSDS2 you could use the lav_dump_valve animation and still have a tailhook left over.....

[Hellhound]

but how would you do that? 20 different flaps isn't there a limit on that? and for the fan you could have a prop in there, constantly spinning

[Hellhound]

and what key (in fs) is the lave_dump_valve animation?

[Felix/FFDS]

and what key (in fs) is the lave_dump_valve animation?

The LDV is basically the water_rudder_rotate keyframe animation tag ...  just with a different name.  Abacus and Louis Sinclair slipped it in as a light hearted part name.

[Hellhound]

urg! if it was a toilet dump (lavoratory dump valve...lol) i would get in the 747 and fly over a city and open it! after finding the aproprate effects...

[contrail_dash]

Lav service is no joking matter!  Trust me on that...its not fun being covered in poo and blue juice. But most of the time its frozen anyways.


I like the idea for the thrust vectoring though!

[Daz]

awwwww they dont.....do they?

[dutch_air_corp]

did i read this good? Isn't it a fact that Engines and their
exaust are "static"in MSFS so you have to choose the engine by type? eh i mean prop, jet, or heli (first 2 are horizontal positioned and vertical is for the heli only

if it is realy possible to vector the trust (exaust) of a MSFS aircraft i realy want have a closer explanation of this item

[Felix/FFDS]

if it is realy possible to vector the trust (exaust) of a MSFS aircraft i realy want have a closer explanation of this item

No.  THe MS Flight Sim does NOT support true thrust vectoring, which is why it is simulated by givng the flaps a very - unrealistically - high lift factor.

[N4733D]

Yep. Give it a huge amount of lift, ruin all realism, and go into a very unstable hover.