vc question(PILOT SHOWS)

[aceronzo]

how do you keep the pilot from being seen in vc mode(CFS2), when building with Gmax?THANX

[Felix/FFDS]

Do not include the pilot figure in the vc "interior" group of parts.?

how do you keep the pilot from being seen in vc mode(CFS2), when building with Gmax?THANX

[aceronzo]

OK Felix Im a DUMMY,I must be missing something on my conversion.If its not too much trouble ,can you explain it  ???

[Felix/FFDS]

If I understand the VC modelling process correctly, you must make a copy of the parts that you want visible from the VC and group them into an "interior" group. and saved as a separate " scene"

The parts that you want visible go into an "exterior" group. and saved as a separate "scene"

Each group is imported into a new "scene" and exported to the sim.

Isn't that the way it's done?  I would presume that your pilot figure is also included in the "interior"  group, and as such, visible in the vc.




[quote]OK Felix Im a DUMMY,I must be missing something on my conversion.If its not too much trouble ,can you explain it

[aceronzo]

I dont know for sure how its done.I just make one scene and export with MiddleMan ect... I will try this.THANX ALOT FELIX.

[aceronzo]

OK that worked Felix THANX, but in the 1st one some txtrs on the windscreen frame didnt make it, so I did it again, and they were ok but a different set ot txtrs didnt make it?? I tried again and back to the 1st txtr not making it.Any suggs on it I am grouping interiors and exteriors from a source I know are complete.The more I learn about Gmax, the more I realize it has to be done perfect or it dont work right!!