Hi! Me again. Got a quick question. I got an Antec 120 LED blue for the side panel of my Antec 900. I want it to draw air from the outside into my case. I have no clue which way it is supposed to mount. I am use to some of these fans having an arrow on them indicating which way the air flows. This one does not. I went to the website for instructions and it was a dead end. It says Antec on one side and you can see the wiring on the other. I am sure if I just install it and once I put the card in tomarrow I could fire it up and do a little paper over the fan test to see if it's in the right direction. I would rather not do that though so I don't have to keep opening the case while I am trying to get the programing done.
Also. Every fan in the case has a 3 speed switch. High,medium,low. I have them all set to high right now. I know this is going to produce quite alot of noise. Being that I am not going to OC right off the bat, the cpu has the stock fan asy, the card has it's own fan (8800 GTS SSC), would there be a problem running them (the case) on say medium or even low?
1 200
4 120,s
1 on the CPU
1 on the Vid Card
2 on the PSU
Thats alot of fans. Maybe I should go a step further and put wings on it and try to fly it instead of using it to fly at home

Mike