Torque.

[Hagar]

Loooks like a result. Always glad to help when I can.

Very nice model too. I wonder if adding 0,0 to other aircraft
would work?

Highly unlikely. It depends on the aircraft. They would all need investigating separately. I was lucky with this one.

It always helps to know which files you're having problems with.

[Anthindelahunt]

The others I can live with such as sibwings Bird dog.

Once again Thanks.

Off for another short flight in the Camel.

[Hagar]

The others I can live with such as sibwings Bird dog.

Sorry, I don't do payware.

Once again Thanks.

Off for another short flight in the Camel.

You're welcome.

[Capt_Cronic]

for future reference;

in the aircraft config file under "[flight_tuning]"

try adding the following line if its not already there

torque_on_roll = 0.3


this is from a piper cub, higher values = higher torque effect

[Anthindelahunt]

Thanks Capt.

Appreciated.

Anthin.

[Krispy1001]

Hi Everyone!

The easiest way to make an aircraft in FSX more manageable to fly especially aircraft like the P51 Mustang. Is to open the aircraft.cfg file and changing the values for p_factor_on_yaw, torque_on_roll, gyro_precession_on_yaw, gyro_precession_on_roll. By default these values are set to 1.0 most of the time. By decreasing the value on these variables you will decrease the effect in FSX.

Example: To reduce the yaw effect to an aircraft that has lots of torque to 50% when taking off. Set p_factor_on_yaw=0.50 . Now if you want to eliminate it completely set p_factor_on_yaw=0.0 .

Each one of the other variables would be changed in the same way.

Hope this helps!

Krispy1001

[Anthindelahunt]

Hi Krispy.

I will try this out tomorrow.

Anthin.

[Krispy1001]

Hi Anthindelahunt!

I should of added, if the above variables are not there then simple add them to the aircraft.cfg file under the heading [flight_tuning].

Here is an example:

[flight_tuning]
cruise_lift_scalar = 1.0
parasite_drag_scalar = 1.0
induced_drag_scalar = 1.0
elevator_effectiveness = 1.0
aileron_effectiveness = 1.0
rudder_effectiveness = 1.0
pitch_stability = 1.0
roll_stability = 1.0
yaw_stability = 1.0
elevator_trim_effectiveness = 1.0
aileron_trim_effectiveness = 1.0
rudder_trim_effectiveness = 1.0
p_factor_on_yaw = 0.0
torque_on_roll = 0.0
gyro_precession_on_yaw = 0.0
gyro_precession_on_roll = 0.0

Thanks, Krispy1001

[Anthindelahunt]

I have tried your suggestions Krispy but no luck.
I tried the default P-51 and it still pulls to the left.

Thanks for trying. I will try other suggestions later.

Anthin.

[Krispy1001]

I have tried your suggestions Krispy but no luck.
I tried the default P-51 and it still pulls to the left.

Thanks for trying. I will try other suggestions later.

Anthin.

Hi Anthindelahunt!

I am very surprised, because that is how I setup my aircraft so they are more enjoyable to fly. Have you tried to change your FSX realism that deals with P-factor, Torque, Gyro? If not set them to a lower level and it will effect all planes globally.

Thanks, Krispy1001