FlyingTrucker wrote:Good evening all...
Starting to think I should Delete this Old Rhinebeck Aerodrome Scenery.
I am getting a Bell Sound as soon as the simulated flight starts and then a screen tells me I am out of memory.....Impossible...

I have 168 GB of Free Space.
I tried other airports in New York State with no problems.
Tried several other locations also...no problem.
Could there be an easy solution to this or should I Delete the Scenery?
Thanks...

This has nothing to do with space on your hard drive even if you had 3TB free you could still get the same message.
It is telling you that you do not have enough RAM
The new scenery you installed is more detailed than any other scenery that you have which is why you do not have problems in those areas.
The rule of thumb here is no matter weather you are installing scenery or aircraft the more detailed it is the more RAM it will need to display it.
One has to remember that if you have a 32 bit operating system the most ram it can see is about 3.4 gig out of 4gig which is the most you can install on a 32 bit system. Even if you were able to put 8 gigs of ram on the mother board your system will only see 3.4 gig if you are lucky. That is just the way it works. My key reason to update to a 64 bit system it does not have this limitation I can put 32 gigs of 2400 hz ram and my system will see every bit of it. No pun intended. All you can do in this case is to lower the sliders on your graphics I would start with the auto gen as that eats most of your RAM.
