Yet another n00b question.

Forum dedicated to Microsoft FS2004 - "A Century of Flight".

Yet another n00b question.

Postby PlutonianEmpire » Wed Oct 04, 2006 5:41 am

What's the difference between a regular go-around and a "published" go-around?
System Specs: HP 2000 Notebook PC; Windows 8.1 64-Bit; 4GB RAM; AMD E-300 APU w/ Radeon HD Graphics (2 CPUs), ~1.3 GHz; AMD Radeon HD 6310.
User avatar
PlutonianEmpire
1st Lieutenant
1st Lieutenant
 
Posts: 336
Joined: Tue Sep 07, 2004 8:49 pm
Location: MinneSNOWta

Re: Yet another n00b question.

Postby JBaymore » Wed Oct 04, 2006 8:08 am

Hopefully this is basically correct .........  ;D

A "published" go-around is a very specific procedure specified in real charts that tells you the exact vertical and horiozontal paths your aircraft should take if you "go missed".
Last edited by JBaymore on Wed Oct 04, 2006 8:15 am, edited 1 time in total.
Image ImageIntel i7 960 quad 3.2G LGA 1366, Asus P6X58D Premium, 750W Corsair, 6 gig 1600 DDR3, Spinpoint 1TB 720
User avatar
JBaymore
Global Moderator
Global Moderator
 
Posts: 10020
Joined: Sat May 24, 2003 9:15 am
Location: New Hampshire

Re: Yet another n00b question.

Postby vololiberista » Wed Oct 04, 2006 9:29 am

As has been said a "published"  ""Missed Approach"" will be a chart and/or written instructions given for an airport with an ILS facility or NDB approach. "Regular" doesn't exist. But an unpublished "missed approach" would be say for an airport without a facility that may instead use a left or right hand circuit for joining, take-off and landing. So, you must know the circuit pattern of an airfield beforehand!!".  And, you're more likely to be flying a GA a/c if joining a circuit.

Let's say you are approaching an airfield with a right hand circuit for rwy 21 (usually at 1,000ft QFE). You are at 7dme and making first contact with the ATC. They may say to you "G-BIZR join right hand downwind for rwy21, QFE 998. So, you set your altimeter to 998 millibars descent to 1,000ft fly across the opposite threshhold of the rwy and turn right downwind.  Call to ATC "G-BIZR downwind for rwy 21", as you turn on base leg make another call, and as you line up for final approach call "G-BIZR finals for 21" ATC may respond "G-BIZR cleared to land, surface wind 230 at one five knots"
THEN, they say "G-BIZR go around, I say again go around, acknowledge" you reply "G-BIZR going around"
You now reset your flaps climb to 500ft QFE fly along the rwy, until the opposing threshhold is past your tail turn right and climb to 1,000ft QFE and rejoin the circuit in a normal way..
That is the unpublished "Missed Approach" procedure!!
Vololiberista
Andiamo in Italia
Image
User avatar
vololiberista
Major
Major
 
Posts: 1042
Joined: Thu Feb 16, 2006 5:43 pm

Re: Yet another n00b question.

Postby PlutonianEmpire » Wed Oct 04, 2006 9:42 am

Wow. :o lol thanks
System Specs: HP 2000 Notebook PC; Windows 8.1 64-Bit; 4GB RAM; AMD E-300 APU w/ Radeon HD Graphics (2 CPUs), ~1.3 GHz; AMD Radeon HD 6310.
User avatar
PlutonianEmpire
1st Lieutenant
1st Lieutenant
 
Posts: 336
Joined: Tue Sep 07, 2004 8:49 pm
Location: MinneSNOWta

Re: Yet another n00b question.

Postby flaminghotsauce » Wed Oct 04, 2006 5:55 pm

There would be a difference if you are IFR or VFR as well. IFR you would want to fly the published so as not to hit anything you cannot see. Or do what ATC tells you at least. VFR you get back in the traffic pattern as explained  by vololiberista above.
flaminghotsauce
2nd Lieutenant
2nd Lieutenant
 
Posts: 181
Joined: Tue May 04, 2004 6:59 pm


Return to FS 2004 - A Century of Flight

Who is online

Users browsing this forum: No registered users and 346 guests