Adding Aircraft Traffic, airport gates, etc, to your Sim - AFCAD, TTools, Project AI, AI Aircraft, etc
by dave3cu » Fri Jun 10, 2011 10:18 am
how can i assign or edit the exit settings of aircraft.cfg for AI to enable the animation of the jetways
You need to edit the [Exits] section. Here is the section from the default 737.
Last edited by
dave3cu on Fri Jun 10, 2011 2:23 pm, edited 1 time in total.
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
-
dave3cu
- Major
-
- Posts: 3141
- Joined: Sun May 19, 2002 9:55 am
- Location: 3CU, Northern Wisconsin, USA
by headtrip » Sat Jun 11, 2011 1:50 am
can you give me a tutorial on how to edit longitudinal,lateral and vertical position?
-
headtrip
- Ground hog
-
- Posts: 17
- Joined: Sun May 29, 2011 9:07 pm
by dave3cu » Sat Jun 11, 2011 7:27 am
Check your PMs
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
-
dave3cu
- Major
-
- Posts: 3141
- Joined: Sun May 19, 2002 9:55 am
- Location: 3CU, Northern Wisconsin, USA
by Liangsho » Fri Aug 26, 2011 1:35 am
Only if it's luxury you have to install any Service Pack, you should make sure you have installed the SDK and related service packs. If you have to accelerate (or gold) should be installed service pack.
-
Liangsho
- Ground hog
-
- Posts: 2
- Joined: Fri Aug 26, 2011 1:43 am
Return to Adding Aircraft Traffic (AI) & Gates
Who is online
Users browsing this forum: No registered users and 437 guests