by dave3cu » Tue May 15, 2012 10:16 am
If you look at the aircraft.cfg for the default Bell 206B (under ..\SimObjects\Rotorcraft\) you'll find annotations above the [contact_points] section explaining the values.
Also in the 'fsxsdk.chm' SDK help file under 'Simobject Creation Kit'.
Example from the 206B:
point.0=3,
Last edited by
dave3cu on Tue May 15, 2012 10:22 am, edited 1 time in total.
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.