Page 1 of 1
Stumbling block
Posted:
Fri Oct 02, 2009 5:09 pmby olderndirt
Using "Rivatuner" to set up a fan speed profile for my video card and encountered a problem in the 'launcher tab' section.
Re: Stumbling block
Posted:
Fri Oct 02, 2009 6:32 pmby NickN
Im not sure what the problem is.. but you would probably be better served going over the the rivatuner forum and posting this..
they have changes in their different RT versions for different driver support and since the revsions can work different for different cards you would be far better off getting an answer from them than here
Make sure you specify the revsion of RT you are using, the driver in use and the video card model
Re: Stumbling block
Posted:
Fri Oct 02, 2009 8:57 pmby olderndirt
Thanks Nick.
Re: Stumbling block
Posted:
Sun Oct 04, 2009 3:51 pmby Plugpennyshadow
Why adjust the speed of the fan on a video card? Is it not running at full speed already or is the goal to slow the fan down?
Curiosity and all that...
Re: Stumbling block
Posted:
Sun Oct 04, 2009 3:57 pmby Plugpennyshadow
I would prefer the fans to run at top speed. The vid card fan is buried too deep in the system for my to hear it and I have just learned to tune out the case fans. They are louder than some I have heard but pull MUCHO heat out of my system.
Im running a stock Intel cooler right now as my Thermaltake poopered out on me. Failure might have had something to do with the cat knocking it off the table, but what would I know.
Running four 120mm fans at whatever rpms they run at simply plugged into the mobo and system is quite cool. Maybe a little over-cool?