Dual Monitor Problems
Posted: Sat Aug 01, 2009 1:54 amI seem to have a problem with dual monitors while using DX10 mode. I have been using DX9 for a while and the FSX uses my (0.0) monitor as the main, but when in Direct X 10 it loads on the secondary monitor (0.1). Normally I would use DX9 but I get way better performance in DX10 because my graphics card is native to it.
I get 8FPS with all sliders maxed on DX9 at major airports and 20fps with DX10 so fixing the monitor issue would be great. However I don't know where to start?
System Specs:
GTX 285
Q9650
8gb ddr2 800mhz Cas Lat 4
Vista 64bit
Main monitor is a Samsung SyncMaster 220 22" 1680x1050
Secondary Monitor is a IBM G78 17" 1600x1200, 1024x768 optimal.
EDIT: I have found a temporary solution which is to run it in a window, drag it to my main monitor and then re-enter full screen. This doesn't fully fix the problem as I get a black screen when i exit until I click back on the desktop ::).
I get 8FPS with all sliders maxed on DX9 at major airports and 20fps with DX10 so fixing the monitor issue would be great. However I don't know where to start?
System Specs:
GTX 285
Q9650
8gb ddr2 800mhz Cas Lat 4
Vista 64bit
Main monitor is a Samsung SyncMaster 220 22" 1680x1050
Secondary Monitor is a IBM G78 17" 1600x1200, 1024x768 optimal.
EDIT: I have found a temporary solution which is to run it in a window, drag it to my main monitor and then re-enter full screen. This doesn't fully fix the problem as I get a black screen when i exit until I click back on the desktop ::).