Triplehead2go help

[Mike..]

So now I have 3 22" flat displays. Triplehead2go is up and running. I went to the Geforce control panel and enabled SLI for my 2 8800 GTS's. The center screen works fine but I can't get the res where I want it. The left screen has sharp res but is pulled toward the left and up not making full use of the screen. The right is doing this as well only more so to the left and up also with sharper res than the center.

This is all impresive and it sucks at the same time. I thought maybe it was a desktop fluke so I ran FSX to see what would happen. The center did the usual load. I went to select a flight and the load screen appeared on my left monitor. When it was finished loading the screen went black but you could here the engines in the back round.........

Current res on my monitor shows it as a whole now instead of 3 screens. The res is set at 3840 By 1024. That's max......


HELP!!!



Mike

[JBaymore]

Mike,

For this kind of stuff it is likely that you'll get a faster response if you go to the Matrox support forums and or call Matrox tech support.

You might also post a reference to THIS question (link to this via posting the "properties" listing in the new messge) down in the "Homebuild Cockpits" forum section.