Page 1 of 1

RAM Problem

PostPosted: Sun Oct 16, 2005 8:07 pm
by ctjoyce
My laptop dosnt want to accept RAM in dual channel, when it did fine before. Now it will accept it in single channel, but when I put in a second stick, it dosnt boot. I need help and fast

Cheers
Cameron

Re: RAM Problem

PostPosted: Mon Oct 17, 2005 1:58 am
by congo
Swap sticks and see if one is actually bad?

If not, maybe a slot is bad?

Try fitting it a few times with attempts to boot each time, might be a dodgy slot.

BIOS reset needed ? (doubtful).

Re: RAM Problem

PostPosted: Mon Oct 17, 2005 5:42 am
by ctjoyce
Ya i think i may have a faulty slot, as i have tried three different sitcks in there, and none work. I also upgraded my bios, so that might be a problem too.

Re: RAM Problem

PostPosted: Mon Oct 17, 2005 7:15 pm
by congo
:o  Well a failure after a bios upgrade would indicate a stinky bios right?

Did you upgrade the BIOS because you were having problems, or just on a whim or bad advice?

Re: RAM Problem

PostPosted: Mon Oct 17, 2005 7:23 pm
by the_autopilot
For dual channel to work, the bios must support it.

Also, ideally, the memory sticks should be identical in terms of speed (ex. ddr400), memory amount (ex. 1 gig) and type (SDRAM).