Simviation Forums

problem just started.  when I raise or lower the elevators they snap back to neutral position.  I just noticed when trying to take off I kept running out of runway then crash. I put the aircraft in spot view and and when pushing in the yoke or pulling out noticed this.

I was flying the beech a36 so I thought it was just this payware so I tried several others pay and included and all do the same.

All other axis work fine,  have calibraited and re calibrated to no avail.  Nothing else has changed.
Can't figure.....Any help appreciated.
Thanks, DSH

Freedomhays,

Check all the assignments that relate to vertical speed, altitude, trim, the autopilot and so in the "assignments" page.

Also if you have another game controller device attached to the computer that has the elevator also assigned...... a small amount of "jitter" in the spikey signal from the pot on that control can change "priority" over to THAT control from the CH yoke.... and suddeenly the elevators go to the "centered" position.

Don't know if that will show anything or not.