Page 1 of 1
X45 problem
Posted:
Sun Dec 05, 2004 5:29 pmby dodger
??? Well, I'm really baffled by this recent development. My Saitek X45 will not give me full deflection of control surfaces, only around 75% or so compared to keyboard actuation. All control surfaces in all a/c in FS2002 are equally affected. Here's the weird part - it works fine in fs9. I have re-installed and re-calibrated to no avail. This is a recent development, noticed it after doing a BIOS update. I have FSUIPC for 2K2 but I haven't used it for any controller calibration yet, (mainly 'cause I haven't figured it out) Could there be a connection here? Any other ideas?? Thanks, folks
Re: X45 problem
Posted:
Mon Dec 06, 2004 11:54 amby Skittles
Obvious question, but it needs to be asked.
Re: X45 problem
Posted:
Mon Dec 06, 2004 9:20 pmby dodger
Skittles, Thanks for the offer. I am gonna take a whack at calibrating in FSUIPC tomorrow. As you said, it starts to make sense after a bit so I'll try it. I'll post results when I have them.
Re: X45 problem
Posted:
Wed Dec 08, 2004 1:57 pmby Ben_M_K
What is FSUIPC??
Re: X45 problem
Posted:
Wed Dec 08, 2004 7:06 pmby dodger
Ben, Not sure I should even attempt to explain since I'm still learning about what it does and how, but I'd describe it as a utility for fine-tuning FS. Go to
www.schiratti.com/dowson and check it out or do a search here for it. there's gotta be lots of info around. Cheers
Re: X45 problem
Posted:
Thu Dec 16, 2004 2:09 pmby dodger
Got it sorted out. Figured out how to calibrate the X, Y and rudder axes using FSUIPC and the controller now gives me full travel. Thanks for the offer, Skittles.
Re: X45 problem
Posted:
Fri Dec 17, 2004 12:31 amby Skittles
Glad to be of help. Do you use other controllers? Yoke or Throttle quadrant? If so, or if you plan to, I created a config swapper to help.
http://www.simviation.com/cgi-bin/yabb/ ... 540;start=