FS9 Saitek Throttle Quadrant problem

[flaminghotsauce]

I just reinstalled FS9 for fun. I have a Saitek yoke and throttle quadrant, with the second quadrant. I run it left to right as throttle one, two, prop one, two, and mix one, and two.

In FS9 the prop one lever will not respond. I have set it, double checked to make sure I was editing the correct quadrant, etc. and cannot make it go. All the other functions of the setup work perfectly.

To double check, I fired up FSX, and all works perfectly. The "Y" axis on the yoke quadrant simply refuses to go under FS9 but works perfectly under FSX....    :-?

Any ideas? Any help appreciated!

[Groundbound1]

I dunno, tried deleting the FS9.cfg and letting the sim rebuild a new one?  :-/

[flaminghotsauce]

Eeeehhh, no. I guess I could try. It's a fresh install of FS9.