I'm sure this topic has been covered in the past but please bear with a newbie!
Just acquired a s/h Saitek X45 stick/throttle combo. Loaded the drivers all seemed OK until I came to calibrate the unit - I then found that the x/y axis for the stick were showing in the top LH side of the calibration screen rather than in the center, the rudder was showing 60% to the right and the throttle wouldn't go past about 70%. All other buttons etc seemed to be OK.
Tried to use it in FSX but was totally useless - as expected.
I've tried looking on the Saitek site and did find a couple of topics in their forums but unfortunately they haven't helped - the one that looked promising had a broken link so couldn't see what that resolution proposed. And Saitek appear to have discountinued support of the X45 unit.
As I said, I'm pretty sure this topic must have arisen in the past so any help would be gratefully received.
thanking all in anticipation
Paul
Simviation Forums
Flight Simulator and other chat
...!
...
...!
....!
...!
...!
