Page 1 of 1

London Thames area

PostPosted: Fri Oct 11, 2019 7:53 pm
by EVVFCX
Hi Guys,

Cast you mind back to the days of FSX :)
There was an issue with rocky/ land mass areas in the Thames river that shouldn't have been there and it was easily solved.
I find that P3D has a very similar problem, does anybody here know of a free fix as there was in FSX?

regards

Steve

Re: London Thames area

PostPosted: Sat Oct 12, 2019 7:46 am
by Bofredrik
Image

Re: London Thames area

PostPosted: Sun Oct 13, 2019 5:57 pm
by EVVFCX
haha :)

Re: London Thames area

PostPosted: Sun Oct 13, 2019 7:08 pm
by Canuck1955
I remember the problem with the original FSX, I though it was sorted with Acceleration. With ORBX I have no problem ewxcept the fps slow to a crawl. London is best avoided..... and in real life to :lol:

Re: London Thames area

PostPosted: Mon Oct 14, 2019 3:07 pm
by EVVFCX
Hi,

P3D are looking into it as well, probably seeing if it's still wet :)

I quite like London, not been for a few years now and I think prob not go again.
Long story but it will end with broken heart.
regards

Steve

Re: London Thames area

PostPosted: Thu Oct 17, 2019 6:44 am
by EVVFCX
Regarding this problem, I thought I'd try side by side comparision running p3d and fsx at same time - you can't do it.
If running p3d and then try to run fsx, it's says already running and same thing happens if you run fsx then run p3d, it says p3d is already running.

regards
Steve