Damage Won't Show

[Biggles]

I'm not sure if anyone will be able to help me with this but here it is.

When playing CFS3 and I get shot up be enemy aircraft the damage textures do not show up so I don't see any bullet holes orlike on the body of my plane.

Also related to this is I cannot apply noseart and wing-tip colours to my aircraft. I can try but it won't show up.

This isn't so much of a problem but an annoyence.
Any help will be greatly appreciated.
Biggles

[SilverFox441]

System specs?

Some graphics cards are limited and those features get disabled.

You might also take a look at the config utility to make sure they weren't turned off.

[Mathias]

Put your aircraft detail slider at least to 3, that should do the trick.

[Woodlouse2002]

Open up CFSconfig and go to custimize then overrides. A box labeled "Dual pass render" will be checked. Uncheck it and press ok.

This should guarentee the damage effects etc. Its always worked for others.

In the long run I recommend a new graphics card.

[Biggles]

Ok thanks guys, I'll check that out. Shoun't be my graphics card 'cause when I first installed got CFS3 running they worked fine.
Biggles

[Biggles]

I found that I already had 'Dual Pass Render' unchecked so it must be my aircraft detail level.
Thanks again
Biggles

[Bogey51]

Mathias hit it right on the head Biggles, at least 3 on the aircraft detail, 4 would be even better.