Simviation Forums

Is There Anyway You Can Change Where Your View In The VC? I Downloaded An Add-on That Gives The TBF Cowl Flaps, Folding Wings, Tailhook, And A Pilots View VC. But This Is What I Get



Heres What  I Get With A Similar Download For The P-39

Can You Help Me?

You can move it anywhere you wish by tweaking the Aircraft.cfg [Views] entries in Notepad. This will involve a little trial & error so start off with small changes & check it out in the sim each time.
This is an example from the default Wildcat. The words after the // are tips & instructions.

[Views]
eyepoint= -3.1, 0.00, 4.0

Thanks Hagar It Took Me Longer To Figure Out How To Upload Pictures And Get Them To Work [Thanks To Sock ] Then It Did To Get A Reply. I Will Try It And See If It Works. If You Want Me To I Can Post The Numbers Here [When I Get It Figured Out]

                           8)Brandon Buchanan8)

Post them if you like. Without having the aircraft I can only guesstimate from your shots.

The idea is to put the viewpoint inside the pilot's head.

The idea is to put the viewpoint inside the pilot's head.

Yep, I've Got Another A/C That Has It Inside The Pilots Heads, I Like, It's Pretty Cool

                                  Brandon Buchanan8)

Brandon
I have the same add on, , here are the view points

avenger

[Views]
eyepoint = -0.8, 0.0, 4.5     //(feet) longitudinal, lateral, vertical distance from reference datum

devastator
[Views]
eyepoint = 1.5, 0.0, 2.8          //(feet) longitudinal, lateral, vertical distance from reference datum

dauntless
[Views]
eyepoint = -1.7, 0.0, 3.5         //(feet) longitudinal, lateral, vertical distance from reference datum


p-39

[Views]
eyepoint = -0.2, 0.0, 2.3          //(feet) longitudinal, lateral, vertical distance from reference datum


Oscar
[Views]
eyepoint=-2.4, 0.0, 3.0  //(feet) longitudinal, lateral, vertical distance from reference datum

betty
[Views]
eyepoint= 7.80, -1.15, 4.60     //(feet) longitudinal, lateral, vertical distance from reference datum

b-25
[Views]
eyepoint= 9.00, -1.25, 2.60      //(feet) longitudinal, lateral, vertical distance from reference datum

b-24
[Views]
eyepoint=11.50, -1.50, 1.50


kate
[Views]
eyepoint = 0.00,0.00,3.0      //(feet) longitudinal, lateral, vertical distance from reference

Val
[Views]
eyepoint=-2.1, 0.0, 3.0    //(feet) longitudinal, lateral, vertical distance from reference datum

hope i was helpful

best regards
Prowler

Thanks Prowler:

You Saved Me From Hours Of Tweaking


                       8)Brandon Buchanan8)