Simviation Forums

Id been using cfs3 for a while and when i booted up cfs2, the cannons started goig berserk.  Every time i pressed the trigger they kept firing until my ammo ran out.  I reistalled it several times.  Then I uninstalled it, deleted the cfs2 folder,  and installled it  again put in the aircraft folder id backed up. It didnt work.  Can anyone help????

Bet this goes back to the first big problem when CFS3 first came out. CFS3 installed a bad version of DX. (Direct X)  Really messed up CFS2 and most couldn't fly in CFS2 again without all kinds of problems. MS even put out a letter after they were flooded with emails for support, apologizing and that they were feverishly working on a solution.  ;D
Go to MS and get DX9.0b and install it. Then check out CFS2. Bet it fixes the problem. Good Luck.

I have DX9 but i dont know if its 9.0b Ill try that.

Just downloaded DX .   STILL doest work

Then the next thing I would suggest is re-install CFS2. Not a complete un-install/re-install, but install the files over the old using the "Use Existing Files" option. Many times this will fix problems. If this does not work, then we will have to go from there.

I just reinstalled it but it still doesnt work  Anything that uses the cannon trigger fires nonstop.

I found the problem.  The #!@*╨  controller to myR/C simulator was causing problems again