investdude wrote:Maybe Hagar will have the answer to this question. I am following the procedure to add the SW Korea Bases.
In the GSL section it says to activate the GSLMan.exe, highlight Korea.gsl, click Add and wait for it to add 26 gob areas. However the GSLMan.exe can only be run from the DEFAULT CFS2 location. I have my Korea CFS2 as a separate install. How can I get GSLMan.exe to run from a separate install? Can I run it from the default CFS2 GSL location and transfer to my Korea CFS2 location?
I realize SW Korea Bases is not part of the Fox Four Korea project. The installations instructions advise to deactivate and remove the Fox Four Far East Scenery pack and I have done that as it is easy to restore it again if necessary. The SW Korea scenery works very well and is an improvement on the Fox Four Scenery but I don't know yet if it will work with Fox Four missions as I haven't tried any yet. If not I will just activate and deactivate sceneries as necessary.
investdude wrote:Just FYI Hagar, I have tried 2 different Fox Four missions and they both worked perfectly with the SW Korea scenery with the very slight defect that on one of the missions the aircraft started out positioned just a little bit short of the runway. I'll try a few more missions when I get time and report back.
Users browsing this forum: No registered users and 288 guests