and spent a few hours getting the sling and winch cable in the right place for a bit of lifting.
Sling load
winching
Piasecki_H21C http://simviation.com/1/search?submit=1 ... &x=19&y=10
upgrade http://simviation.com/1/search?submit=1 ... p&x=16&y=9
To enable sling save flight, go to the saved .FLT and change
[Sling.1.0]
Object=
CableLength=0
HoistSwitch=0
to
[Sling.1.0]
Object=
CableLength=65
HoistSwitch=0
and add to the bottom of aircraft cfg
[Sling.0]
hoist_extend_rate = 5 //Feet per second
hoist_retract_rate = -5 //Feet per second
position = 10.2, 4.6, 8.0 //Feet from datum
max_stretch = 2.0 //Max stretch distance at ultimate load
damping_ratio = 0.6 //0 for no damping to 1.0 for critically damped.
rated_load = 600 //Characteristics tension of cable in pounds
ultimate_load = 2250 //Breaking force in pounds
tolerance_angle=45 //Angle, in degrees, used to determine lateral breaking force limit
auto_pickup_range = 8 //Max Range, in feet, for auto-pickup
auto_pickup_max_speed = 8.5 //Maximum speed (feet per second) for auto-pickup
hoist_payload_station = 0 //Payload station in which the hoist will load in and out of. 1 is first station.
hoist_door=1 //Door associated with hoist. Must be open for use.
[Sling.1]
position = -3.0, 0.0, -2.8 //Feet from datum
max_stretch = 2.0 //Max stretch distance at ultimate load
damping_ratio = 0.75 //0 for no damping to 1.0 for critically damped.
rated_load = 10000 //Characteristics tension of cable in pounds
ultimate_load = 25000 //Breaking force in pounds
tolerance_angle=70 //Angle, in degrees, used to determine lateral breaking force limit
auto_pickup_range = 8 //Max Range, in feet, for auto-pickup
auto_pickup_max_speed = 8.5 //Maximum speed (feet per second) for auto-pickup
The only problem is the door does not open on the models with a winch but does open on the civilian model when you press ctrl +U.
WINCH CONTROL KEYS
Hoist Arm (Extend/Retract) CTRL+U
Hoist Cable (Lower) J
Hoist Cable (Raise) K
Hoist Cable (Attach/Release) O
