Simviation Forums

Man am I lost!!!!





Nice kite, no VC but the exterior model is amazing! Needs a decent and authentic 2d panel methinks (I'm off to find one now)

Nice,downloaded this last night,not managed to find a vc as yet.....

Dave

Er, have you lost your marbles Mark? You're the wrong way up!

Mark, just turn southwest and fly 7 or 8 minutes, land in Valleyfield and i'll have my horses waiting.  ;)

I'm still allergic to horses Danny, but a cold beer or 27 would be welcome

Been a while since I've seen you post any pics Mark

Very cool ones they are too...Fly down west for around half hour and you'll end up in my neck of the woods... 8-)

have you downloaded the panel off their site? it is really realistic...

nice shots..definetly a bit lost though

their is a panel available from the HJG page (at the bottom) along with a new soundset.

i downloaded this bird but when i try and use it, it freezes my sim.

their is a panel available from the HJG page (at the bottom) along with a new soundset.

i downloaded this bird but when i try and use it, it freezes my sim.

It might be the panel that's causing it. Did you read the installation instructions?

Please read the Installation section of the BAe 146 Panel Manual
before installing this Panel. This is very important because
otherwise some special things will not work and in the worst
case the Flightsimulator crashes!

PS. Just tried the panel. I have the same problem.

i did indeed follow it, seemed like a normal panel installation with an extra bit bolted on.

it is indeed the panel that is causing my FS to freeze, i removed the aircraft, and just installed it as it comes (no new panel) and it did not freeze.

il give it another read and install tomorrow and see what happens, if the same i will try and submit this as a bug report o the HJG

shame, i really want to fly this aircraft. it looks really nice

mine works fine with the panel...

you are absolutely sure you did exactly what the installation instructions say?

Don't bother asking for directions, they'll just answer questions with quastions, ay?

mine works fine with the panel...

you are absolutely sure you did exactly what the installation instructions say?

Yup. Well, maybe not exactly as I would never extract zipfiles direct to FS or advise others to do so.

I've tested a great many 3rd party panels of all descriptions over the years. I'm usually the one that figures out the answer to these problems.

i did indeed follow the instructions, and like hagar i did not directly unzip into the FS9 directories.

im gonna have another mooch at it, but its kinda odd, been simming for about 7 years now and this has never happened to me before.

still i did a small circuit with the model using the b737 panel and sounds and its really nice to fly

Have another try with that panel & give it time to load. This might take a while. http://www.simviation.com/cgi-bin/yabb2/YaBB.pl?num=1196090106