Simviation Forums

I don't know If you can see it in this pic, but look to the rear of the Delta aircraft and you will notice that the default mesh is popping up on top of the scenery mesh. I don't understand why this is happening.

I deleted the first Boston scenery I had, I never encountered this until I set up a flight From New York to Boston on a 777. When I made final into Logan little pop ups like that one were scattered all over airport, it was terrible.

I don't know what caused this, Usually if I program the game to take me directly to Logan I don't have this issue. But If I pick a flight to land here I get these pop ups as if the scenery wasn't properly loaded.

Any suggestions on how to correct this!

 I have not noticed that glitch. Ithink its only on your computer.

i don't have that  ???

Do you use a Raedon card...I've seen that in places in my FS...and I use Raedon.

yup I have a Radeon card (9800xt) so it is in the graphics card? Is it time for me to update the drivers or something (i thought it does that on its own).

I dunno yet, but I will check.

I recently flew again and I think something buggy goes on with my graphic card when I fly for a long period of time. Almost as if I fly for too long a period I get glitches.

It is pretty weird but it never happens regardless of what I fly as long as I load logan airport first and fly out of the airport.

But taking off from other airports and flying to logan presents the issue noted in the pic.

I think it's a glitch with Raedon cards...it also has to do with the Afcad being too low.

So it is up to the designer to raise the afcad a little bit huh. Oh well.

But the funny thing is I don't encounter that issue when I start my FS at Logan.

Oh well, time for me to stop repeating myself and just deal with it! It is still an awesome scenery!

happens at schiphol all the time, especially on rw22 (GA)

My Boston on  a  Nvidia 9500xt.