Page 1 of 1

Camel update

PostPosted: Wed Jun 22, 2011 1:02 pm
by expat
It has been quite some time since the last update. Unfortunately life has gotten in the way. The upper wing is now complete except for the internal rigging. It has been dummied up to check for dihedral of the lower wing and the correct length of the struts. I am beginning to feel as if I am on the home leg, but still quite a bit to do.

Matt

Image

Image

Image

Image


Image

Re: Camel update

PostPosted: Wed Jun 22, 2011 2:30 pm
by Flying Trucker
Awesome job Matt...you must have a lot of patience... ;)

Re: Camel update

PostPosted: Thu Jun 23, 2011 9:17 am
by expat
Awesome job Matt...you must have a lot of patience... ;)


The amount of swearing that goes on, Mrs Ex-Pat would disagree with you ;D

Matt

Re: Camel update

PostPosted: Thu Jun 23, 2011 4:46 pm
by B-Valvs
Amazing work! It looks awesome.

8-)

Re: Camel update

PostPosted: Sun Jun 26, 2011 4:05 pm
by jlab58
i never saw any model so detailed. i see you have plans but is this coming in a kit?

Re: Camel update

PostPosted: Mon Jun 27, 2011 2:14 am
by expat
i never saw any model so detailed. i see you have plans but is this coming in a kit?



Yes it is a kit - Model Airways. I would like to do the Jenny, but space for the finished item would pose a rather large problem.

Matt

PS, at the end of the page, it says "intermediate Level", so long as you have been making model kits since you are about six years old (I am 43) then yes it is intermediate