Goodly evening all...
Well they say Practice makes Perfect and I need a lot of Practice...
Took your advice again Stephane "Daube" and tried the following screenshots...
Think I messed a couple up...
Windows 10 Professional and Microsoft FSX Deluxe with Acceleration
ORBX Scenery
Location for circuits is Bowerman Airport "KHQM", Washington State, USA
Early evening simulated flight
Carenado Cessna 337H simulated aircraft...
REX Plus Overdrive
FSWC (Flight Simulator Water Configurator)
Most sliders are still at 70% in FSX and 30 for Frame Rate
From copilots seat
Taxiing out...wondered about this shot
Not sure how much detail I was going to get taking these screenshots at Dusk or Night
Departing but remaining in Circuit for several touch and goes
Now this screenshot might have been a waste of time...I tried a side shot and did not like it either
Tried to accomplish showing the Gear going down...Perhaps the Cessna 337 was not the simulated aircraft to try this screenshot on...not sure
On Final
Perhaps should have shifted camera back to copilots side
Touchdown...this was an actual Full Stop and taxi back in to ramp...after three or four approaches I found myself making more mistakes...
Saved Flight...will probably try it with another light twin another night...
Comments and advice most welcome...