Page 1 of 1
Tiger Meet

Posted:
Fri Aug 21, 2009 8:56 pm
by Bruce448

img]http://www.simviation.com/yabbuploads/tigerm04.jpg[/img]


Bruce
Re: Tiger Meet

Posted:
Sat Aug 22, 2009 2:29 am
by jankees
wow, now that is some paintscheme!
Is that the new 2000 by Rollus?
Re: Tiger Meet

Posted:
Sat Aug 22, 2009 3:22 am
by Bruce448
wow, now that is some paintscheme!
Is that the new 2000 by Rollus?
It is Jan
Re: Tiger Meet

Posted:
Sat Aug 22, 2009 5:49 am
by The-Black-Sheep
Niiiice! :)
And where can we get the aircraft?
Alec
Re: Tiger Meet

Posted:
Sat Aug 22, 2009 6:17 am
by Bruce448
[quote]Niiiice!
Re: Tiger Meet

Posted:
Sat Aug 22, 2009 11:23 am
by olderndirt
Number two is a great shot.
Re: Tiger Meet

Posted:
Sat Aug 22, 2009 12:38 pm
by EJW
Nice!
Re: Tiger Meet

Posted:
Sun Aug 23, 2009 12:51 am
by gtirob01
Love that paint. I did download it and it installed just fine, but I just cant seem to keep the darn engine running. During start I set fuel to full rich... but it still doesnt start. Is there a startup procedure? Im sure there is... but I dont know French!
Re: Tiger Meet

Posted:
Sun Aug 23, 2009 4:22 am
by Bruce448
Love that paint. I did download it and it installed just fine, but I just cant seem to keep the darn engine running. During start I set fuel to full rich... but it still doesnt start. Is there a startup procedure? Im sure there is... but I dont know French!
It is a "Cold & Dark" cockpit but very simple to start. Right now there is no English manual which presents a problem to get all the needed info on what does what. There's a panel on the right which also has a pop-up panel in which the throttle is on. All the switches needed to start are there.

This screen shot shows the panel pop-up. Left to right is the sequence. The bottom is the engine N rotation gauge. Set the switches as shown and in the third screen, advance the throttle about 1/4 open. That's it.
Re: Tiger Meet

Posted:
Tue Aug 25, 2009 10:54 pm
by gtirob01
ok cool, was able to get the engine running. Problem now is that on my takeoff run, I get to about 80kias and the power just cuts out... but the engine remains on. Not sure what that is all about.
EDIT - ok, fixed the power cut problem by resetting the flight. No more problem there. Only problem i have now is that when I press G to retract the landing gear, it moves a little, but then goes back down. The only way to keep the gear retracted was to actually hold down G. Theres gotta be an easier way.
Re: Tiger Meet

Posted:
Fri Aug 28, 2009 7:33 am
by RaptorF22
When I try to go to the page to download it I just get this message: blocked service stop of the system.
Is this payware?
Re: Tiger Meet

Posted:
Fri Aug 28, 2009 8:26 am
by Bruce448
ok cool, was able to get the engine running. Problem now is that on my takeoff run, I get to about 80kias and the power just cuts out... but the engine remains on. Not sure what that is all about.
EDIT - ok, fixed the power cut problem by resetting the flight. No more problem there. Only problem i have now is that when I press G to retract the landing gear, it moves a little, but then goes back down. The only way to keep the gear retracted was to actually hold down G. Theres gotta be an easier way.
If you look on the left hand side in front of the throttles you will find a yellow and black striped bar to prevent the gear lever being raised on the ground, just move ot out of the way.
When I try to go to the page to download it I just get this message: blocked service stop of the system.
Is this payware?
Silly question first,
1. Have you registered?