Page 1 of 1

Tube-flying again!

PostPosted: Mon Jul 20, 2009 12:15 pm
by Alonso
Now that I got my new 22'' monitor and configured the gorgeous FS9 Bloom to my taste, I took the PMDG 737-7W out from Newark to St. Maarten. 8-)

Enjoy! ;)



Taxiing:
Image






Out of EWR:http://www.simviation.com/yabbuploads/alxcokewrtncm2.jpg






Cruising over San Juan:
Image






Slowly descending:
Image







Runway in sight!:
Image





Booo!! No low pass! >:(:
Image







Landed safely and resting at the terminal...
Image




----
Hope you liked the shots... Really enjoyed this flight! 8-)

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 12:31 pm
by scalper_old
second last shot is cool.

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 12:56 pm
by tcco94
I loved them all :D

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 2:01 pm
by SubZer0
Wow these look great Alonso

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 5:40 pm
by a1
Great set. Your bloom looks fantastic. May I have the settings you use? I am a bit busy with stuff now so I dont' have time to test. ;)

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 7:02 pm
by BigTruck
Looks great!!

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 10:34 pm
by Alonso
Thanks for the comments guys! ;)

a1, this is my setting:

Code: Select all
[BLOOM]
BloomPowerDay=7
BloomFadeTime=2000
BloomConstantDay=1
BloomQuality=0
BloomScreenLevelDay=54
BloomCurveDay=0
BloomPowerNight=13
BloomConstantNight=5
BloomCurveNight=0
BloomScreenLevelNight=24
BloomAdaptationScreenLevel=80
BloomAdaptationMultiplier=10
BloomAllowOversaturation=1

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 10:58 pm
by Jersey Flyer
Hey Alonso, is that the Newark Scenery by imagine simulations?

and if it is, how are your frame rates over there? I have a decent system and yet they're TERRIBLE at Newark, they're fine anywhere else like flytampa's st. maarten.

Re: Tube-flying again!

PostPosted: Mon Jul 20, 2009 11:47 pm
by a1
Thanks for the comments guys! ;)

a1, this is my setting:

Code: Select all
[BLOOM]
BloomPowerDay=7
BloomFadeTime=2000
BloomConstantDay=1
BloomQuality=0
BloomScreenLevelDay=54
BloomCurveDay=0
BloomPowerNight=13
BloomConstantNight=5
BloomCurveNight=0
BloomScreenLevelNight=24
BloomAdaptationScreenLevel=80
BloomAdaptationMultiplier=10
BloomAllowOversaturation=1



Thanks. :D

Re: Tube-flying again!

PostPosted: Tue Jul 21, 2009 1:16 am
by Alonso
Hey Alonso, is that the Newark Scenery by imagine simulations?

and if it is, how are your frame rates over there? I have a decent system and yet they're TERRIBLE at Newark, they're fine anywhere else like flytampa's st. maarten.


Yes, it is. Framerates drop with full traffic. With my specs below and 50% traffic I get about constant 24FPS. With 100% traffic I get 16-18FPS...

I also get very good frames with Flytampa TNCM, but maybe that's because there are usually only a few planes there. (Compared to Newark)

Re: Tube-flying again!

PostPosted: Tue Jul 21, 2009 2:34 pm
by Jersey Flyer
Hey Alonso, is that the Newark Scenery by imagine simulations?

and if it is, how are your frame rates over there? I have a decent system and yet they're TERRIBLE at Newark, they're fine anywhere else like flytampa's st. maarten.


Yes, it is. Framerates drop with full traffic. With my specs below and 50% traffic I get about constant 24FPS. With 100% traffic I get 16-18FPS...

I also get very good frames with Flytampa TNCM, but maybe that's because there are usually only a few planes there. (Compared to Newark)



Ah okay I'm about the same as you are then, I was just wondering if I was alone.. I wish the scenery wasn't so heavy on the frames..

Re: Tube-flying again!

PostPosted: Tue Jul 21, 2009 10:13 pm
by francsal
:o :o :o

Speechless!!! Great set, Alonso!!!

And I would be extremely happy to have those FPS with that scenery....  :D