Page 1 of 1
A day at the Beech!
Posted:
Sun Dec 23, 2007 1:38 amby Wing Nut
Carenado's Swallowtail Bonanza...
A few from today's cruise around Tampa Bay. I happen to think the Swallowtail is one of the best looking GA planes in aviation and planes like this are why payware is made. It speaks volumes for Carenado when you consider this is an FS2004 plane in FSX. ;)
Climbing out of Albert Whitted in St Pete.
Grabbing some sky.
One mile and not a peep from the Controllers...
On final int Lakeland/Linder. Yes, I am too high as I'm sure SOMEONE will point out... ;)
Touchdown! The crowd goes wild!
Re: A day at the Beech!
Posted:
Sun Dec 23, 2007 12:23 pmby SubZer0
Are you using SP2/Acceleration?
I have these aircraft but in SP2/Acceleration, the prop textures are so messed up it's not even funny. And the panel textures, well that's even worse, they're see-through lol.
Re: A day at the Beech!
Posted:
Sun Dec 23, 2007 1:02 pmby Wing Nut
Yeah, you can really see it in the third shot. I keep hoping for a patch but until then, it's still a great plane to fly...
Re: A day at the Beech!
Posted:
Sun Dec 23, 2007 4:09 pmby Harold
Carenado really makes some very good stuff don't they? Very nice models and indeed too bad about the prop textures ... what is causing that anyways?
Re: A day at the Beech!
Posted:
Sun Dec 23, 2007 4:18 pmby Wing Nut
I'm not sure, but the VC is screwed up as well. Still, even with that, it's an exceptional plane, and I really prefer the 2d panel anyway...
Re: A day at the Beech!
Posted:
Sun Dec 23, 2007 4:20 pmby Harold
I really prefer the 2d panel anyway
I really don't care for a panel at all ... I'm an outside guy
Re: A day at the Beech!
Posted:
Mon Dec 24, 2007 2:58 amby -Crossfire-
I can't believe nobody's told you this yet... but in #4 your a little to high ;D
Re: A day at the Beech!
Posted:
Mon Dec 24, 2007 4:09 amby Wing Nut
I've always felt that it's better to be too high than too low... ;)
Re: A day at the Beech!
Posted:
Wed Dec 26, 2007 12:59 pmby SubZer0
I really prefer the 2d panel anyway
I really don't care for a panel at all ... I'm an outside guy
Lol Harold.
It's a shame that SP2 has caused all these prop and panel texture problems
and it's not just with these planes.
They really are very good models and feel great to fly, but i'm a VC guy and like my textures right. We'll have to wait for their patches, hopefully not much longer.