by eno » Fri Nov 19, 2004 3:46 am
I agree ..... that screenshot looks stunning ...... However not all of us have your knowledge or the resourses to be able to tweak and twiddle enough to get those results.
On the average machine used by Joe Bloggs the results aren't quite as impressive. Now whilst my initial post might have been slightly misleading I still stand by my original statement, a payware mesh used with the default scenery/landclass will give a better result without the need to alter CFG files.
It will also drain less processing power which for most people is a more convincing argument.
As has been said in so many posts about how to get the best perfomance with various PC specs/ Graphics cards, software should do what it shows on the box on the recommended settings not on settings that for most people are unattainable. I have tried the VFR Scenery on my old 500mhz machine and on this machine (specs below) which is well above the recommended specs .... I'm still not convinced.
I admire the work that you do Ramsa and I have been impressed by the results you have achieved on the likes of Savas' machine. I am even considering using your services myself. However the poster asked for good and bad points and you are in the privilaged position of being able to tweak to the Nth degree to bring out the good points....... Joe Bloggs average doesn't have that knowledge.
VFR Scenery.
The bad points ..... It doesn't run well on the minimum settings ... It takes ages to load up... Even on the recommended settings with more than adequate processing power it still fails to live up to expectations... Too much tweaking required to get even reasonable results.
cheers
eno
[align=center][img]http://www.simviation.com/yabbuploads/imaginsigeno.jpg[/img][/align]